A DIYer's Way To Fix A Brick Driveway
Unfortunately, sealer, applied onto the brick pavers, isn’t able to prevent the mechanical damage. In other words, the cracks and chips which appear if, for instance, something is dropped on the brick pavers, are inevitable. Obviously, such damage is quite selective and far from being crucial, as it’s totally possible to pull a few cracked bricks out of a paved driveway and replace them with the new ones.
This simple guideline will help you do conduct a solid repair and secure the new pavers in place without ruining the surrounding pavers. Thus, take a broom and thoroughly sweep the driveway to get rid of the dust and debris. Be quite particular about the mortar seams around the pavers. This is also a good chance to remove the oil stains on your driveway that have been bothering you for a while.
Rub them off using the mixture of room temperature water and white vinegar. If there’s some dirt or grime left on the pavers after you swept them, get rid of it using a wet soft-bristled brush. Once that’s done, wash your brick driveway using a garden hose, so that the water under the strong pressure removes the rest of the dirt and dust and leaves the surface crispy clean.
Make sure that the driveway is completely dry before proceeding to the next steps. While your driveway is drying, find the damaged bricks, mark them with chalk not to miss any and inspect them to figure out whether you’re able to repair them or they have to be replaced. Masonry contractors note that even if the brick paver has a few cracks on its surface or its corner is chipped, you might be able just to turn in upside down and reinstall with the ‘pretty’ side facing up.
But, you’ll have to extract the pavers to know that for sure. Using a hammer and a chisel, break down the mortar around the damaged brick until you’re able to pull it out of its place. Assess the damage and, if the brick appears to be quite crumbly or if the entire paver is covered in a web of cracks, toss it away, as you won’t be able to reuse it. If you may turn the damaged side inwards, save the brick for later.
Don’t forget to remove the mortar crumbles and clean the holes in your driveway left after the brick extraction. Sometimes it’s quite difficult to find the brick pavers, which would match the ones that are installed on your driveway just due to the discoloration that happens to the brick after a long-term exposure to the sun and precipitations. Thus, if you don’t want your patchwork to be too obvious, you might have to treat the replacement brick to match its color to the rest of the driveway.
If the new pavers turn out to be a few shades darker than you need, brush them with milk/yogurt and let them dry to lighten their surface. If they’re too light or don’t look as weathered as the rest of the driveway, make them look so by brushing some dirt or ash into its surface. When that’s finished, prepare the mortar mix following the instruction on its package.
Grab some mortar mix with a trowel and apply approximately a 3/4-inch layer of it onto the hole the brick will go into. Then, take the replacement brick, spray its sides (apart from the top one) with some water, spread a thin layer of mortar on them and press the brick down in place so that it is level with the surrounding pavers.
Remove the excess mortar around the freshly installed brick, clean the seam to make it crisp and you’re done. Additionally, you may apply a layer of sealer onto the repaired areas to prevent the premature weathering. Please enable JavaScript to view the comments powered by Disqus. LandscapingHardscaping is the term used to describe solid materials and elements implemented into traditional and modern landscapes to diversify them, makes them more practical and amp up outdoor living areas.
